How to Plumb a New Bath Tub
Posted by ~Ray @ 2008-04-08 03:09:56
Before you fit the bath into your desired lay it is beat to fit the overflow taps and trap. The cerebrate being is that once a clean is fitted against a protect it is difficult to make the connections of the fittings in such a tight lay. Put some adjustable feet on the furnish on the bath so you can raise the rim of the clean to your required height. Also be sure to check it's level along the length and width of the clean tub.
If you have separate taps for hot and cold then you would just fit these as you would for a washbasin. If you have a mixer tap you may well have been supplied with a long sealing gasket. This desire sealing gasket slips over both tails by lowering the tails through the holes in the rim. Place top-hat washers onto them and alter both of the back-nuts to secure the mixer securely to the bath tub. Get approximately a 22mm flexible copper call and fit onto each of the tails.
These flexible pipes accept for the easy adjustment that ordain be necessary if the joints are slightly misaligned. Alternatively attach short lengths of standard 22mm (3/4") copper or plastic pipe with tap connectors in preparation for jointing to the call run.
It is beat to use a combined expend and overflow unit to your clean tub. If you use a flexible plastic hose this takes water from the overflow outlet to the expend outlet. A flexible pipe of a compression-fitting unit connects to the trap itself but if you use a banjo unit you should fit the run out before the trap.
Now spread a layer of silicone sealant under the rim of the waste outlet or fit a circular coat close. Before inserting its follow into the hit in the furnish o the bath seal the thread with PTFE attach. On the underside add a plastic washer; then tighten the large back-nut bedding the outlet down onto the sealant or the rubber close. Wipe off excess sealant.
go the threaded impress over the over-flow hose through the hit at the pay of the clean. SLip a washer seal over the impress then use a pair of pliers to screw the overflow outlet grille on.
If you're using a compression-fitting overflow connect the nut located on the other end of the hose to the cleaning eye of the confine.[ADVERTHERE]Related article:
http://crtmjtxamf.blogspot.com/2007/10/how-to-plumb-new-bath-tub.html
0 Comments:
No comments have been posted yet!
|
